Exult Forum

Is there a port for Yopy ? If not, is one planned ?

What's Yopy?

To answer my own question: http://www.yopy.com/

Any idea if SDL works with it?

So you found out what Yopy is.

I don't know if SDL works with Yopy, I assume it does.

And another question: does Exult work on the new Zaurus SL-C700 ?

http://www.dynamism.com/zaurus/index.shtml

To answer my own question _again_: there was some talk on the SDL mailing list about the Yopy around june last year, but nothing after that.

Apparently the problem was that the framebuffer (quote) "uses 16 bit pixels, but requires 32 bit writes"

The response mail might be implying that it might work if you only use SW surfaces, but without access to a yopy it would be hard to test

AFAIK, it should be possible to run exult on the zaurus SL-C700.

Artaxerxes