Setting Offsets for New Shapes?
Forum rules
NOTICE: This forum is archived as read only.
Please use the Github Discussions at https://github.com/exult/exult/discussions
NOTICE: This forum is archived as read only.
Please use the Github Discussions at https://github.com/exult/exult/discussions
-
Knight Captain
- Posts: 1219
- Joined: Thu May 14, 2020 1:34 pm
Setting Offsets for New Shapes?
There hasn't been much discussion about setting offset for new shapes and sprites. How can I set these correctly?
-
agentorangeguy
- Posts: 565
- Joined: Thu May 14, 2020 1:34 pm
Re: Setting Offsets for New Shapes?
I've had some success with just trial and error, changing the Origin (x, y) settings as needed until I found the right setting.
-------------------------------------------------------------------------------------
Ultima 6 Mod for Exult site: http://www.ultima6.realmofultima.com/
Ultima 6 Mod for Exult site: http://www.ultima6.realmofultima.com/
-
Knight Captain
- Posts: 1219
- Joined: Thu May 14, 2020 1:34 pm
Re: Setting Offsets for New Shapes?
With that being the lower right corner to offset from?
-
agentorangeguy
- Posts: 565
- Joined: Thu May 14, 2020 1:34 pm
Re: Setting Offsets for New Shapes?
I think so, and adjusting the x, y as needed with trial and error you should be able to find the right setting
-------------------------------------------------------------------------------------
Ultima 6 Mod for Exult site: http://www.ultima6.realmofultima.com/
Ultima 6 Mod for Exult site: http://www.ultima6.realmofultima.com/